Embroidery paper-cutting is a technique in which embroidery is done separately and then sewn on the project. It is faster and easier than traditional surround technology. Stand-alone embroidery can be placed and aligned exactly the first time without additional stress and frustration. Although this technology has existed in different forms for a long time, Jenny Haskins has extensively developed and elaborated on her quilts and other projects, and she is the person who created the names used here.
Depending on the design and the desired look, there are several options for creating an embroidery cut. The design is combined with a nylon organza on a hoop stabilizer and then cut out. Stabilizer selection and cutting techniques can vary depending on project requirements.
Because only stabilizers and lightweight, smooth fabrics are used together for embroidery, it is recommended that they be more securely fastened to the hoop instead of using the hoop alone. Three ways to secure the stabilizer more securely are to use double-sided application tape, veterinary wrap tape or a rubber shelf pad window. For double-coated tape, tape the tape to the bottom of the inner ring. This technology has the lightest retention, but has the least interference with the hoop and is the easiest to use. The veterinary bandage is a self-adhesive bandage that can be wrapped around the inner ring. It will only stick to itself, so it won't make it hoop. The more consistent the package, the more uniform it will be. The gripper holder liner is a very effective hooping tool with excellent fixability. Cut a rectangular rubber shelf liner that is at least one [1] inch larger on each side than the hoop to be used. Separate the hoop and cut a window leaving a margin of about one-half inch inside. When a separate stabilizer or lightweight fabric is hooped, this window is located at the top of the fabric, just below the inner ring for better fixation. Another benefit of embroidered paper cuts is that if your stirrups work hard, there are still wrinkles in the fabric, and most of the time they don't matter.
The layer held in the loop will be a combination of a nylon organza, a clear polymeric stabilizer and a reticulated wash-off stabilizer. Usually two layers are used, for example two layers of polymer, a transparent hard yarn plus polymer, or a transparent hard yarn plus washing, but some heavier designs will better suture three layers, two stabilizers and an organza in two Between or at the top. An organza yarn with a layer of stabilizer has two advantages over the use of two layers of stabilizer. The organza provides additional stability and support for the design and is much less expensive than stabilizers.
The choice between polymer and wash depends on the washability of the embroidery. If you want to make a separate velvet or silk applique, using a polymer stabilizer will be the preferred method because velvet or silk should not be wetted. If you design a knit appliqué or need more continuous support, Polymesh is also a good choice. However, most designs work well with wash-off or polymerization stabilizers.
The easiest way to cut the embroidery is to use a hot cutting tool, such as a stencil burner. It is essential that rayon be used with embroidered paper, especially if the design is cut with a hot cutting tool, as the polyester thread will melt. Be sure to place glass cutting boards or large pieces of glass on the work surface. Use a sharp tip on the hot cutting tool and run it on the edge of the design when it is hot enough. It should cut fabrics easily and cleanly. For designs that may require trimming of fabrics and stabilizers, such as patches and decals, apply a stop solution to the fabric along the outer edge of the stitch. When dry, trim small and sharp scissors around the edge of the embroidery. .
There are two common methods when applying embroidery to a project. The first is to use transparent monofilament lines and free dot stitching on the outside of the embroidery. The second method uses rayon to match the satin stitch outline and stitch the embroidery to the item using narrow satin stitches.
This technology can also be combined with traditional circular embroidery to achieve a layering effect. Endless benefits and possibilities.
Orignal From: Simple machine embroidery technology, perfect fit
No comments:
Post a Comment